2.8 CYD SPI with Chameleon Ultra

2.8 CYD SPI (Duggie Build)
Chameleon Ultra – Advanced RFID

This is the real deal. A complete, ready-to-run handheld — hand-wired by Duggie. No soldering, no sourcing, no guessing. Open the box, flash your favorite firmware and go.

One of one. Built by hand. Never another exactly like it.

The build:

• 2.8 SPI CYD in the Duggie Edition PLA Pro Equtiment Grey case
• 1000mAh flat lithium cell — internal, rechargeable
• Full power stack: charging board, boost, buck, boot switch, power switch — all wired and tested

Radios on board (all quick-detach):

• NRF24L01 — 2.4GHz transceiver
• CC1101 — Sub-GHz transceiver
• Dipole 2.4GHz antenna
• Tri-band Sub-GHz antenna for the CC1101
• GPS via ATGM336 with a ceramic GPS antenna built into the case — no external antenna to snap off
  
  THIS BUILD DOSE NOT HAVE RFID

Every radio module is wired on quick-detach connectors — if one ever fails, swap it in seconds. No desoldering, no rework, no downtime.

Extras:

• Integrated stylus holder (with stylus)
• 8GB SD card included — ready for logs, captures, and configs
• USB-C charging

Quality: Every unit is hand-wired by Duggie personally and bench-tested for a minimum of 2 days before shipping. Radios verified, GPS lock confirmed, battery cycled, touchscreen calibrated. If it leaves my bench, it works.

This isn't functional out of the box there is no firmware on the device. However this is a finished tool, built the way I build my own — and this particular unit is a true 1-of-1. But it arrives in a non functional state without firmware.